Audi S4 Logo Brake Caliper Decals / Stickers Kit

6x decals per kit approx. 2x 71x25mm   2x 63x20mm   2x 55x17mm
Made from Superior Quality High Temperature Cast Vinyl

Supplied in 2 colour parts

If you would like a kit with the 'BREMBO' logo instead,
Please buy from this listing and send an email to confirm 'BREMBO'

Self Adhesive,   Easy to Fit,   No Mess !!

 

Available in 4 Colours

Black + Red    White + Red   Silver(Met) + Red   Dark Grey(Met) + Red

 

Benefits of Superior Cast Vinyl

  • Lifespan                            8 - 12 years
  • Shrinks                             No  (never) 
  • Superior Adhesive            Yes             
  • Thinner                             Yes             
  • More Durable                    Yes            
  • Heat Resistant                  Yes            
  • Weather Resistant            Yes            
  • Stronger Colours                   Yes              
 

Remember!    If it's not Cast, it's not Quality!

 

Fitting Instructions

Thoroughly clean and degrease the surface. Use Methylated Spirit or Isopropyl Alcohol to degrease.
Cut the sheet into individual logos. ( Not individual letters )                                                                  
Place a decal face down, rub all over, then peel off the backing ( squared paper ).                              
Position the decal in the desired location then rub firmly all over.                                                          
If the surface you are applying to is cold, heat with a hairdryer, then rub all over again.                       
Peel off the application paper with care.                                                                                                
                      If there are any air bubbles simply prick with a needle and push the air out.                                                              
Repeat with the red parts which are fitted with clear application tape to aid alignment.                                         
DO NOT wash for at least 24 hours to allow the adhesive to cure.