LexJet Dry Erasable Gloss Laminate 2 Mil enables prints to be converted into write- on/wipe-off boards that have the changeability of a chalkboard, but with much less mess.
Buyers of these types of graphics can use dry-erase markers from any office-supply stores to write daily specials on colorfully printed signs, call attention to important details in photographs enlarged for courtroom graphics, or keep everyone in the office, classroom, or home apprised about the activities and goals for the week.
LexJet Dry Erasable Gloss Laminate 2 Mil was previously known as 2 Mil Dry Erasable Laminating Film.
| Product Type | Laminates & Coatings |
| Adhesive Type | Pressure Sensitive |
| Applications | POP / Indoor Signage |
| Dry Erase Boards | |
| Finish | Gloss |
| Smooth | |
| Laminate & Coating Type | Pressure Sensitive |
| Material | Polypropylene |
| Properties | Description |
| Applications | This product is recommended for producing general purpose graphics, decals and unprinted substrates for use with dry erase pens. Typical substrates are paper, cardboard, photos and unprinted substrates. If producing industrial grade dry erase boards or multi layer laminates of either plastics or metal consult with your Concept sales representative. These include sign in boards typically found in hospitals, retail establishments and restaurants. For best results, we suggest the following dry erase brand marking pens: Avery Marks-a-lot® (chisel point), Expo Scents® (chisel point), Expo Bold color® (chisel Point), Expo regular® (chisel point) brand marking pens. |
| Material | 2 mil high performance polypropylene |
| Adhesive | 1 mil clear permanent acrylic pressure sensitive |
| Release Liner | 4 mil smooth paper liner |
| UVA Light Protection | No; indoor use only |
| Inkjet Media Preparation | Printer manufacturers recommend that you allow your print to dry for a minimum of 24 hours before lamination. In areas with high humidity dry times can be longer. |
| Laminator Compatibility | All LexJet laminates are provided on 3" standard cores. |
| Laminator Settings | Apply 40-80 psi and use 2-5 feet per minute for dwell time. Between 90° to 100° F heat is recommended, but heat is not required. The top and bottom web tension should be minimal. |
| Adhesive Cure Time | After applying the laminate, allow curing for a minimum of 2 hours before cutting or trimming. Maximum bond strength is reached in 24 hours. |
| Dimensional Stability | Film can react to heat in processing. In laminating process do not use excessive unwind tension or nip roll pressure as curl could result. |
| Min. Application Temp. | 40° F (4° C) |
| Service Temp. Range | -40° F to 200° F THIS IS NOT A LAMINATOR SETTING. |
| Expected Exterior Life | Limited. Dry Erase Film has limited resistance to UV exposure. Test fully for any extended outdoor use. |
| Adhesion | 48oz/in to stainless steel |
| Adhesion | PSTC-1 with 24-hour dwell at 70°F and 50% relative humidity. |
| Adhesion | Typical values. Individual values may vary. Test thoroughly before production. |
| Water Resistance | Good. Immersion not recommended. |
| Humidity Resistance | Good. |
| Ideal Storage Conditions | 70° F (21° C), 50% R.H. (a controlled environment is recommended); store vertically in original packaging. |
| Shelf Life | 1-year shelf life when stored in ideal conditions. |
| Tip | For best results, we suggest the following dry erase brand marking pens: Avery Marks-a-lot® (chisel point), Expo Scents® (chisel point), Expo Bold color® (chisel Point), Expo regular® (chisel point) brand marking pens. |