1:200 Scale  Plastic Snap-Fit – Airbus A350-900 Delta Airlines – Length:13"  Wingspan: 12.5"

These models from Flight Miniatures are made of plastic and don't need any glue or paints. The assembly is very basic and takes only a few minutes. Assembly consists of nothing more than attaching the wings to the fuselage and then attaching the tail and elevators. Special care has to be taken while attaching the wings since the fitting in these models is quite tight and some pressure needs to be applied. The pressure needs to be applied on the wings and onto the fuselage. Do not, for example, hold the wings from the engines and apply force like that since this will damage and/or break the engine.

The level of detail is very nice and accurate. Wings will show the different panels and sections just as the real thing. The coloring and markings are not decals, so they won't peel off. For the people who are really observant, engines are accurately proportioned and the type of engine is also accurately represented. These type of models are the type which one can see in airline offices and/or at travel agents (when they were still around).

This is not a toy. Recommended for 15 and up.

The Airbus A350 is a long-range, wide-body twin-engine airliner developed and produced by Airbus. The initial A350 design proposed in 2004, in response to the Boeing 787 Dreamliner, would have been a development of the Airbus A330 with composite wings and new engines. Due to inadequate market support, Airbus switched in 2006 to a clean-sheet "XWB" (eXtra Wide Body) design, powered by two Rolls-Royce Trent XWB high bypass turbofan engines. The prototype first flew on 14 June 2013 from Toulouse, France. Type certification from the European Aviation Safety Agency (EASA) was obtained in September 2014, followed by certification from the Federal Aviation Administration (FAA) two months later.