*Due to phones or monitors showing color shades differently, colors may vary from what is on your screen.*Keep in mind 3D printed parts will have texture. Think of them like model car parts. May need a light sanding, A xacto knife trimming small supports or paint if you wish. Usually 1 side was attached to the printer bed and it may be the roughest. Lightly sand and usually fine. Thanks again for your interest.
~Stomper 4x4 rear body tab fits Chevy Nomad. This is the long clip as shown. The slot is a little larger than original to accomodate several size tabs. 3D printed can be glued in with krazy glue.
May have elmers glue on the side washes off with warm water!
*Front one is the new one. The rear one is original for reference only.
Photos are part of the description. Zoom in and judge for yourself. Most of these I stuck a battery in to see if it works but otherwise are as found condition. Sold as is.
Condition is Used. Shipped with USPS
Vintage 80s Stompers like most Electronics can stop working during shipping. Typically you can put a fresh battery in them and tap them on the bottom and they will start working again. Sometimes the solder will come loose which is also easily fixed. Battery not included. Smoke free home!