Order 4 or more connectors and receive a free roll of Nashua wire harness tape.

Please compare the connectors on your vehicle and ensure you're ordering the correct version. Note the position of the ears on the connectors.

CONNECTOR ASSEMBLY CONSISTS OF THE FOLLOWING COMPONENTS:

• Connector Housing (20% glass reinforced)
• Grommet cap (20% glass reinforced)
• TPA (Terminal Position Assurance) component (20% glass reinforced)
• CPA(Connector Position Assurance) component (20% glass reinforced)
• Matte seal (Inherently lubricated silicone)
• Interfacial seal. (Inherently lubricated silicone)

Electrical Specifications :

• Voltage: 250V
• Current: 22.0A
• Contact Resistance: 10 milliohms max.
• Dielectric Withstanding Voltage: 500V DC
• Insulation Resistance: 20 Megohms min.
•  

INSTRUCTIONS:

You will want to reuse your factory original wiring and terminals. 

1. Simply remove the wire/terminal assemblies from the old connector (feel free to break it apart as you have new ones! Just be careful to not damage your wire/terminals). 

2. Do note the position of each wire in relation to the connector.  I have included a connector diagram from Ford. Your wire colors may vary.

3. Insert the wire/terminals into the new connector. You will hear each click into place.

4. Push the white TPA inward to lock the terminals in place.

5. Install connector onto coil and push the red CPA forward to lock the connector in place.

6. Rinse and repeat with each connector.

7. Done.

Below is just a few models this connector fits: